Skip to content
IoTronix Solution

Hardware and embedded design

Custom electronics, from idea to certified board.

The team that builds FactoryOS hardware also designs custom PCBs and firmware for other companies. We take each project from requirement to a working, certified board.

For machine builders, OEMs, R&D and product companies, and factories that need hardware they cannot buy off the shelf.

Exploded drawing of an IoTronix sensor node: lid, circuit board, base and clamp sensor. RS-485 and CAN Bus lines bring readings into the board, and LoRaWAN sends them out.RS-485CAN BusLoRaWANenclosure lidour PCB + firmwarebase, machine mountclamp on power cable

Six steps, one team, from requirement to small-batch production.

  1. Step 1

    Requirements and architecture

    What the board must do, where it will be used, how it connects.

  2. Step 2

    Schematic and PCB layout

    Designed in-house by the engineers who will test it.

  3. Step 3

    Firmware

    Embedded code on ESP32 and Texas Instruments microcontrollers, connectivity and over-the-air updates.

  4. Step 4

    Prototype, fabrication and assembly

    Working boards that you can test on the real machine.

  5. Step 5

    Testing and certification

    Including SIRIM certification.

  6. Step 6

    Small-batch production and support

    From 50 units, supported by the team that designed it.

Interfaces

What our boards connect to in the factory.

  • RS-485
  • CAN Bus
  • LoRaWAN
  • Modbus RTU/TCP
  • MQTT
  • Wi-Fi
  • PLC I/O

Boards we have built

Designed, built and now in use.

Perfomax

Perfomax · maritime, Singapore

Custom CAN Bus to LoRaWAN gateway

Collects engine data from vessels, where cabling and signal are difficult. Delivered with a vessel engine performance dashboard.

Oriental Nichinan Design Engineering, Teck See Plastic Group

ONDE · product R&D, plastics

Machine condition gateway

Designed and built for injection moulding machines that had no ready-made connection. It connects over RS-485.

FactoryOS

Our own product

The FactoryOS ESP32 gateway

Built for 24/7 factory floors. It connects old machines to FactoryOS without changing how they run.

See how these gateways connect old and new machines
Wong Wee Ken

Lead engineer

Wong Wee Ken

Co-Founder and Director of Technology · Embedded Systems and Hardware Engineer

B.Eng Mechatronics (Hons), 8+ years in factory automation. Builds custom sensor hardware for factories that run 24/7, instead of using ready-made devices.

Questions about custom hardware

Do you build connected devices for other companies?

Yes. If you are looking for IoT development in Malaysia, this is that service. We design the PCB, write the firmware on ESP32 or Texas Instruments chips and build custom IoT devices, quoted per project.

What is the smallest production run?

Small-batch production starts from 50 units, supported by the team that designed the board.

Can you help with SIRIM certification?

Yes. Testing and certification, including SIRIM certification, is one of our six steps. Our SIRIM guide explains the regulators, the tests and the official fees.

Discuss your hardware project.

Tell us what the board must do and where it will be used. We quote per project.